SiO2 Infused Ceramic Wax

Ensure the vehicle is fully cleaned and decontaminated from other products. 

Apply a small amount of the product to a foam/ microfibre applicator and work panel by panel, spreading the product thinly and evenly across the surface. 

Work the product into the panels using one of the below methods. 

1. Using small, overlapping circular motions, or, 
2. The ‘crosshatch’ style; moving it in straight lines across the panel one way and the at 90o in the other direction. 

Allow the applied product to cure for 5-15 minutes depending on the ambient temperature and humidity.  

Fold a clean microfibre buffing cloth into four and without pressure begin removing the left-over product.  

Rotate the towel to reveal a fresh side frequently for best results.  

No dilution necessary. 

Spreading into the thinnest and most even layer possible will ensure the product cures efficiently, buffs off easily and provides the best results and durability possible. 

Carefully swipe a finger through the wax once applied and note how the product moves under your fingertip. If it smears on the surface and leaves a greasy mark it is usually too early to remove. If the product is removed cleanly and smear free; it is a good indication that the product is cured and ready to come off.